GN Solids Control drill cuttings dryer is widely used in drilling site oil-based mud non-landing projects. It is the core equipment for oil-based mud non-landing. In order to ensure the normal operation of GN Solids Control drill cuttings dryer, we use it daily During the process, attention should be paid to the maintenance and maintenance of the dryer to ensure that the drilling site operations are not affected.to make sure it can working with other equipment like decanter centrifuge in drilling waste management system
The GN Solids Control drill cuttings dryer must be started under no-load conditions. If it is started under load, it will cause serious damage to the equipment and may even harm the operator. During the use of the schedule, a routine inspection of the drill cuttings dryer should be done every shift. The inspection content includes: 1. Whether the dryer has abnormal vibration on site; 2. Whether the lubrication system has oil leakage or other abnormal phenomena; 3 , Whether there is looseness in each fastening part; 4. Whether the slurry inlet and slag discharge port are blocked; 5. Whether the temperature of the main bearing is lower than 90 degrees during operation.
In addition to daily inspections, drill cuttings dryers must be inspected regularly after the machine has been running for a period of time. Regular inspections include: 1. Check the condition of the belt after every one thousand hours of operation, whether the tightness is moderate, whether it needs to be replaced for wear, etc.; 2. Check each connection every time the operation exceeds one thousand hours or the vibration is excessive Check whether there is any looseness and check whether each sensor is working normally; 3. Clean the oil filter of the drill cuttings dryer with kerosene every 30 days, and check whether the oil quality needs to be replaced, and the longest use of the oil should not exceed 6 months; 4. Check the oil level every two weeks, and replenish new oil in time if the level is lower than the standard level; 5. Regularly clean the slag outlet, flush the slurry outlet and the sieve blue, and check whether the sieve basket is damaged; 6. Regularly Check the wear of the scraper, the sieve basket scraper and the sieve basket, and replace them if they are damaged.
Welcome contact GN Solids Control if you are interested about our product