GN Oil -based mud drilling dumping dried machine sold to foreign mud companies

Last week, the oil -based mud diamond dumpling machine produced by GN Solids Control was sold to a mud company abroad. The following specifically introduced:

1. GN solids Control Drilling cutting drying machine

Drilling cutting dryer by GN Solids Control is mainly used to treat oil -based rock chips and synthetic base rock chips. After the drilling rock scrap dried machine is treated, the oil content on the rock chips can be controlled below 5%. The model of this supply is GNCD930G, which is designed for integrated module, including containers, screw conveyors, centrifugal pumps, hanging ups and hanging devices.

Core equipment drilling vertical cutting dryer machines mainly include sieve baskets and rotors. These two main components run in the same part at different speeds. Solid particles that are more than 250 microns can be separated from rock chips. The rock crumbs produced by GN Solids Control have different sized sieve baskets of 3, including 250 microns, 350 microns and 500 microns. There is a difference between the speed between the rotor scraper and the sieve basket. The remaining solids that remain on the inside of the screen basket are continuously scraped off by the scraper and transported to the bottom of the sieve basket. The scum discharge port is collected and the discharge machine is extended to achieve the drying of drilling.

 Vertical-Cuttings-Dryer-2023.02.23 (1)

GN Solids Control has provided hundreds of drill chip drilling machines for global companies such as Baker and Shell.

GN Decanter Centrifuge

Decanter centrifugal machine is one of the key equipment for drilling mud solid -phase control and drilling waste treatment. There are many rotating sizes produced by GN Solids Control to choose from, including 9 -inch, 14 -inch, 18 -inch, 22 -inch, and 30 inches. The drum material is made of two -way stainless steel SS2205 or SS32304. It has better performance. The abrasion -resistant cover of the residue port is a tungsten carbide hard alloy cover, which is extremely abrasion -resistant and is not easy. At the same time, the feeding device is protected by replaceable wear -resistant alloy tablets, with long service life and easy maintenance.

GN Solids Control is a 14-inch horizontal centrifugal machine, model GNLW363D-VFD, the same integrated design, including containers, liquid pumps, and spiral conveyors.

The integrated design of the two modules can meet fast installation and transportation, and can also meet the use of low -temperature areas in winter.

If you have equipment requirements or solution consultation in this area, welcome to call GN Solids Control