Apr 13

How to use a vibrator of shale shaker, it contains two keys: disassembly of the bibrator of shale shaker, reassembly of shale shaker. And you need exactly remmber that disconnect power to the electric motor and lock the disconnect swithch in the open position.

Disassembly of the Vibrator of Shale Shaker
WARNING: Disconnect power to the electric motor and lock the disconnect swithch in the open position.

Shale Shaker Motor

Shale Shaker Motor

1. Remove motor and drive pulley guard.
2. Remove the counterweight guard from both ends of the vibrator shaft.
3. Loosen the four motor support bolts located under the motor, loosen the V-belts and remove them.
4. Remove the V-belt sheave , by first loosening its taper lock hub.
5. Remove the counterweights , by removing the clamp screws and reusing the screw to open the slots in the counterweights, by tightening the screws into the tapped holes.
6. Remove the collars  and the retainers  with the Spiro lox rings  in their grooves. Remove cartridge cap screws.
7. Remove retaining ring  from the drive side only. By striking on one end of the shaft  with a lead hammer or a hammer and a block of hardwood, it is possible to start to drive out the cartridge  on the other side.
8. Then it should be easy to pry either or both cartridges loose from their bores in the housing ends. If difficulty is experienced a cartridge can be bumped from the inside by striking the shaft again at the other end. When one cartridge is removed the shaft can be slipped from the housing. Continue reading »

written by GN solids Control \\ tags: , ,