Apr 11

Drill cuttings are separated by shale shaker, decander, desiler, decanter centrifuge, and collected by screw conveyor or vacuum unit , for further separation of vertical cutting dryer & decanter centrifuge.

drill cuttings separation

drill cuttings separation

In an ideal situation, all drill solids are removed from a drilling fluid by solids control equipment on a drilling operation. The two primary sources of solids are chemical additives and formation drill cuttings. Drill cuttings are contaminants that degrade the performance of the drilling fluid. If the drill cuttings are not separated, they will be ground into smaller and smaller particles that become more difficult to remove from the drilling fluid.

Most formation solids can be removed by mechanical means at the surface. Small particles are more difficult to remove and have a greater effect on drilling fluid properties than large particles. The particle size of drilled solids incorporated into drilling fluid can range from 1 to 250 microns (1 micron equals 1/25, 400 of an inch of 1/1000 of a millimetre).

Continue reading »

written by GN solids Control \\ tags: , , , , , , , , ,