Shear pump is also called shearing pump,which is a centrifugal pump,but used for shearing of drilling mud chemicals,shearing the bentonite.
GN make centrifugal shearing pump for drilling mud solids control system.
| A | CENTRIFUGAL PUMP (6″ x 8″)
(For Shearing of Mud Chemical) |
||
| 1 | CENTRIFUGAL PUMP | Nos | 2 |
| Capacity – 1000 GPM @ 100 FT Discharge Pressure | |||
| @ 22 PPG | |||
| Size – 6 x 8 R | |||
| Shaft Size – 1 7/8″ | |||
| Impeller Size – 12″ | |||
| Motor – 100 HP, 1500 RPM, 3 Phase, 400 V, 50 HZ | |||
| Classification – Explosion Proof | |||
| Note – Starting Motor To Be Soft Start System | |||
| SPARES FOR CENTRIFUGAL PUMP | |||
| 9 | Shaft | Nos | 4 |
| 10 | Impeller (12″ Dia) | Nos | 4 |
| 11 | Wear Plate | Nos | 4 |
| 12 | Bearing | Nos | 16 |
| 13 | Housing | Nos | 2 |
| 14 | Oil Seal | Nos | 16 |
| 15 | Gland Packing | Nos | 3 |
JQB series Shear Pump is a special purpose equipment of solids control system which can meet all customers’ requirements of preparing dilling fluid for the well drilling system. This shear pump manufactured by GN company is used to treat the high property mud, make the mud to obtain good rheological properties and cut the drilling cost as much as possible. This ideal solids control equipment designed by GN’s engineers has high performance and gained customer’s high evaluation.
Awaiting your reply for the Centrifugal pump for shearing of drilling mud Chemical and thank you for your continue support.